Sharp MX-2614N

TEST SIMULATION
SHARP
46
51
Resist Roller Adjustment
1
Secondary transfer voltage ON timing
adjustment
2
Resist roller adjustment
53
Document Feeder Adjustment
6
RSPF document tray size adjustment
7
RSPF document tray size adjust value set.
8
RSPF scanning position adjustment
9
RSPF dirt detection setting
10
RSPF dirt detection execution
55
MFP Data Setting
1
Engine soft switch setting
2
Scanner soft switch setting
3
Controller soft switch setting:-
SW1-5
Auto clear function before copy
job execution:-
0 =Disabled, 1 = Enabled
SW3-6
Process mixed original size
printing for duplex mode:-
0 =Disabled, 1 = Enabled
SW3-7
HP Compatibility Mode:-
0 =Disabled, 1 = Enabled
SW4-5
Paper type simplification
selection:-
0 =Disabled, 1 = Enabled
SW4-7
Paper feed size entry:-
0 =Disabled, 1 = Enabled
SW6-1
Ethernet Speed Auto
negotiation:-
0 = Enabled, 1 = Disabled
SW6-2
Ethernet Link Speed:-
0 = 100Base TX, 1 = 10Base T
SW6-3
Ethernet Duplex Mode:-
0 = Full, 1 = Half
SW6-4
Ethernet 100/1000 Link Speed:-
0 = 100Base TX, 1 = 1000Base T
SW6-8
USB Card Reader detection
control
0 =Disabled, 1 = Enabled
SW9-5
Maintenance notification setting
by Printer MIB:-
0 = Enabled, 1 = Disabled
SW22-5
Display toner remaining (MFP
Status):-
0= Disabled, 1 = Enabled/Display
55
MFP Data Setting
3
Controller soft switch setting:-
SW24-7
Continuous print mode for OSA
(job queuing for external
accounting):-
0 = Job Queue Disabled
1 = Job Queue Enabled
SW24-8
OSA Offline Mode (for external
accounting):-
0 = Disabled, 1 = Enabled
SW25-7
Custom Envelope size (Printer).
0 = Disabled, 1 = Enabled
SW26-1
Notification sound of finished
Copy job.
0 = Disabled, 1 = Enabled
SW26-2
Notification sound for Stop copy
when no original is present
0 = Disabled, 1 = Enabled
SW27-7
Set printable area to same as
previous model
0 = CR3 series (Default)
1 = CR2 series
SW27-8
Retain Scan to Desktop
destination for a certain period
after a scan operation.
0 = Disabled (Default)
1 = Enabled
SW28-3
Single Email alert notification for
customer.
0 = Disabled (Default)
1 = Enabled
SW28-4
Envelop mode – automatically
change to size tab screen.
0 = Disabled (Default)
1 = Enabled
SW28-6
Disable Multi Shot & Pamphlet
function when reprinting
retention data.
0 = Disabled (Default)
1 = Enabled
SW28-7
The [X] keys indicating
determination of setting can be
changed to [OK] keys
0 = Disabled, 1 = Enabled (Default)
10
Special Stamp setting (Taiwan only)