MX-5111N MX-PNX1A/B/C/D (PUNCH MODULE) 10 – 2
2) Remove the coin screw, and remove the finisher slide stopper.
3) Slide the inner finisher further more.
4) Remove two screws, and remove the front cabinet upper.
5) Remove the screw, and remove the band and the punch cover.
6) Remove the screw, and remove the dummy punch unit.
7) Fix the punch unit with a screw.
* When installing the punch unit, be careful not to bump it
against the drawer connector.
* Fit the positioning pin and insert it.
8) Make positioning with the dove (A) and fix the punch unit with
the screw which was fixing the dummy punch unit.
9) Cut the lid of the punch cover with nippers.
To Next Page
Loading...
