2-91
COPIER►OTHER FUNCTIONS
4
Sets a movement distance.
Tap the area indicating the movement distance on the front
or reverse side, and enter the distance using numeric keys.
After the settings are completed, tap and [Back] keys in
sequence.
• To quickly set the area, first specify a value close to the desired value by the numeric keys, then adjust it with .
• If you set the [Adjust 2nd pg value to 1st.] checkbox to , goes out and you can set sides 1 and 2 separately.
• If you want to copy in the horizontal orientation, specify "Left" as the starting side of the original.
Even if you copied in the horizontal orientation, setting the starting side of the original to the top enables measurement
of the movement distance in the same way as in the vertical orientation.
To cancel the Position Image setting:
Tap the [Clear] key.
5
Place the original.
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
► AUTOMATIC DOCUMENT FEEDER (page 1-82)
► DOCUMENT GLASS (page 1-84)
To cancel all settings:
Tap the [CA] key.
6
Tap the [Colour Start] or [B/W Start] key to start copying.
Others
Position Image
Please designate print start position.
Preview
Start
Colour
Start
Back
A3
Change Size/Direction.
Original
Colour Mode
2-Sided Copy
Clear
Side2Side1
Fit Back Face to Front Face Value
0
0
00
X
Y
( -432~432 )
mm
( -432~432 )
mm
( -297~297 )
mm
( -297~297 )
mm
Erase Shadow Around
Erase
X
Y
CA
B/W
To Next Page
Loading...
