2-94
COPIER►OTHER FUNCTIONS
Changing the copy settings for each set of originals
As necessary, change copy settings for each set of originals.
Perform the steps below before scanning the next set of originals in step 4 of "Copying in job build mode (page 2-92)
".
A [Separator Page] setting cannot be changed for the second and later sets.
1
Tap the [Change Setting] key.
2
Change copy settings.
3
Place the next set of originals and tap the [Start] key.
Repeat this step until all originals have been scanned.
To Next Page
Loading...
