8
Wave length 790 nm ± 10 nm
Pulse times
MX-6240N/MX-7040N
Normal paper mode (P/S = 178 mm/s) = (3.49 µs ± 0.02 ns) / 7 mm
MX-6240N/MX-7040N
Normal paper mode (P/S = 225 mm/s) = (2.76 µs ± 0.02 ns) / 7 mm
Heavy paper mode (P/S = 95 mm/s) = (3.27 µs ± 0.02 ns) / 7 mm
Output power Max 0.672 mW (LD1 + LD2)
Caution
Use of controls or adjustments or performance of procedures other than those
specied herein may result in hazardous radiation exposure.
This Digital Equipment is CLASS 1 LASER PRODUCT (IEC 60825-1 Edition 2-2007)
SAFETY PRECAUTIONS
This Digital Equipment is rated Class 1 and complies with 21 CFR 1040.10 and
1040.11 of the CDRH standards. This means that the equipment does not produce
hazardous laser radiation. For your safety, observe the precautions below.
• Do not remove the cabinet, operation panel or any other covers.
• The equipment’s exterior covers contain several safety interlock switches. Do not bypass any
safety interlock by inserting wedges or other items into switch slots.
“BATTERY DISPOSAL”
THIS PRODUCT CONTAINS A LITHIUM PRIMARY MEMORY BACK-UP
BATTERY THAT MUST BE DISPOSED OF PROPERLY.
PLEASE CONTACT YOUR LOCAL SHARP DEALER OR AUTHORIZED
SERVICE REPRESENTATIVE FOR ASSISTANCE IN DISPOSING OF THIS
BATTERY.
This product utilizes a CR coin Lithium battery which contains a Perchlorate
material. Special handling for this material may apply, California residents,
See www.dtsc.ca.gov/hazardouswaste/perchlorate/
Others, consult local environmental ofcers.
This product utilizes tin-lead solder, and uorescent lamp containing a small
amount of mercury. Disposal of these materials may be regulated due to
environmental consideration. For disposal or recycling information, please
contact your local authorities, the Electronics Industries Alliance: www.eiae.org,
the lamp recycling organization: www.lamprecycle.org or Sharp at 1-800-BE-
SHARP. (For U.S.A. Only)
Laser information
CAUTIONS
To Next Page
Loading...
