Sharp MX-B200 User Manual

8
70
Transfer charger
If copies start becoming streaky or blotchy, the transfer charger may be dirty. Clean
the charger using the following procedure.
1
Turn the power switch off. (p.8)
2
Ensure that the multi-bypass tray is open and then open the
side cover while pressing the side cover open button.
3
Take the charger cleaner out by holding the tab. Set the charger
cleaner onto the right end of the transfer charger, gently slide
the cleaner to the left end, and then remove it. Repeat this
operation two or three times.
4
Return the charger cleaner
to its original position.
Close the side cover by
pressing the round
projections near the side
cover open button.
5
Turn the power switch on. (p.7)
Slide the charger cleaner from the right end to the left end along
the groove of the transfer charger. If the cleaner is stopped on
the way, smudges on copies may occur.

Sharp MX-B200 Specifications

General

Print Technology	Laser
Print Speed	20 ppm
Maximum Print Resolution	600 x 600 dpi
Copy Speed	20 cpm
Scanner Type	Flatbed
Functions	Print, Copy, Scan
Paper Capacity	250 sheets
Interface	USB 2.0
Dimensions	518 x 445 x 298 mm
Paper Size	A4, A5
Fax Transmission Speed	33.6 kbps
Operating System Compatibility	Windows
Memory	64 MB (Standard)