6
CAUTIONS
Handling precautions
WARNING
Do not place a container of water or other
liquid, or a metal object that might fall inside,
on the machine.
If the liquid spills or the object
falls into the machine, fire or
electrical shock may result.
Do not remove the machine casing.
High-voltage parts inside the machine may cause
electrical shock.
Do not make any modifications to this machine.
Doing so may result in personal injury or damage
to the machine.
Do not use a flammable spray to clean the
machine.
If gas from the spray comes in contact with hot
electrical components or the fusing unit inside the
machine, fire or electrical shock may result.
If you notice smoke, a strange odor, or
other abnormality, do not use the machine.
If used in this condition, fire
or electrical shock may result.
Immediately switch off the
main power and remove the
power plug from the power
outlet. Contact your dealer or
nearest SHARP Service
Department.
If a thunder storm begins, switch off the
main power and remove the power plug from
the outlet to prevent electrical shock and fire
due to lightning.
If a piece of metal or water enters the
machine, switch off the main power and
remove the power plug from the power
outlet.
Contact your dealer or nearest SHARP Service
Department. Using the machine in this condition
may result in electrical shock or fire.
CAUTION
Do not look directly at the light source.
Doing so may damage your
eyes.
Do not block the ventilation ports on the
machine. Do not install the machine in a
location that will block the ventilation ports.
Blocking the ventilation ports will cause heat to
build up in the machine, creating a risk of fire.
The fusing unit and paper
exit area are hot. When
removing a misfeed, do
not touch the fusing unit
and paper exit area. Take
care not to burn yourself.
When loading paper, removing a misfeed,
performing maintenance, closing the front
and side covers, and inserting and removing
trays, take care that your fingers are not
pinched.
Fusing
unit
Paper
exit area
mxb402_us_sta.fm Page 6 Monday, June 14, 2010 3:46 PM
To Next Page
Loading...
Need help?
General
