Sharp MX-C301W

SHARP
COLOUR CALIBRATION
11
MX-C250F, MX-C300W
Note: When adjusting colour balance before or after routine maintenance, always use the
recommended paper (Mondi 90gsm or equivalent) for optimum image quality.
Manual Colour Calibration [COPY MODE]
HIGH DENSITY PROCESS CONTROL:
[Execute]
Sim 44-06
ENGINE COLOUR BALANCE ADJUSTMENT:
Sim 46-24 [Auto Adjustment]
Place printed test pattern onto OC glass.
MANUAL COLOUR DENSITY ADJUSTMENT:
Sim 46-21 [for Engine]
Adjust CMYK (17 points) for Copy Mode.
SET HALF TONE PROCESS CONTROL TARGET
[Execute]
Sim 44-21
HALF TONE PROCESS CONTROL EXECUTION
[Execute]
Sim 44-26
Manual Colour Calibration [PRINTER MODE]
Prior to checking or adjusting Printer Colour Balance Adjustment, ensure to execute Engine Colour
Balance Adjustment (as described above):-
MANUAL COLOUR DENSITY ADJUSTMENT:
Sim 67-25 [for Printer]
Adjust CMYK (17 points) for Copy & Printer Modes.
PRINTER DENSITY CHECK:
Sim 64-05 [PCL Printer]
Sim 64-06 [PS Printer]