HALF TONE COLOUR CALIBRATION
Sim 46-24 Colour Balance Adjustment/Calibration [MX-C250/300 only].
Sim 46-74 Colour Balance Adjustment/Calibration [MX-C301W only].
COPY IMAGE QUALITY
Check Image Quality (Copy Mode) – Density, Magnification, Lead Edge & Void.
If NG, perform the following adjustments as required:-
Sim 46-01 Copy Density Adjust. (Colour).
Sim 46-02 Copy Density Adjust. (B/W).
Sim 46-09 SPF Copy Density Adjust.
Manual Adjustment (Magnification, Lead Edge, Void, Off Centre etc).:
Sim 48-01 Magnification Adjustment (OC & SPF).
Sim 50-01 Lead/Rear Edge, Loss & Void Adjust.
Sim 50-12 OC & SPF Off Centre Adjust.
PRINT IMAGE QUALITY
Check Image Quality (Print Mode) – Density.
Sim 64-05 PCL Density Test Page.
Sim 64-06 PS Density Test Page.
FACSIMILE
Sim 66-02 Fax SW Setting (Destination).
Sim 66-10 Fax Memory Clear.
OPTION CONFIGURATION
EXTERNAL ACCOUNTING MODULE – MX-AMX3
Sim 55-03 Auto clear function before Copy job execution:-
SSW 1-5 0 = Disable, 1 = Enable.
Sim 55-03 USB Card Reader detection control:-
SSW 6-8 0 = Disable, 1 = Enable.
Sim 55-03 Continuous print mode (job queuing for OSA):-
SSW 24-7 0 = Disable, 1 = Enable.
To Next Page
Loading...
