Sharp MX-C507P - Page 248

5028
149 errors
149 error messages
Motor (output) service check
Diagnostics and troubleshooting
214
Action
Yes
No
Step 1
Reset the printer.
Does the problem remain?
Go to step 2.
The problem is
solved.
Step 2
Check the cable on the motor (output) and on the JOUTDC
connector on the controller board for proper connection and
damage, and replace if necessary.
Does the problem remain?
Go to step 3.
The problem is
solved.
Step 3
Reset the printer.
Does the problem remain?
Go to step 4.
The problem is
solved.
Step 4
Replace the motor. See “Motor (output) removal” on page 334 .
Does the problem remain?
Go to step 5.
The problem is
solved.
Step 5
Reset the printer.
Does the problem remain?
Go to step 6.
The problem is
solved.
Error code
Description
Action
149.80
The motor (output) did not turn on.
See “Motor (output) service check” on
page 214 .
149.81
The motor (output) did not turn off.
149.82
The motor (output) speed did not ramp up to the
required level.
149.83
The motor (output) stalled.
149.84
The motor (output) ran too slow.
149.85
The motor (output) ran too fast.
149.86
The motor (output) did not run at the correct
timing.