Sharp MX-C507P - Page 433

5028
4 Tighten the screws.
5 Perform a color alignment adjust. See “Color alignment adjust” on page 282 .
Developer hold down removal
1
2
3
4
Remove the top cover. See “Top cover removal” on page 305 .
Remove the controller board shield. See “Controller board shield removal” on page 392 .
Remove the printhead. See “Printhead removal” on page 397 .
Pull the bell crank and spring off the mounting pin.
5
Pull the bell crank (B) and spring (C) off the mounting pin.
Parts removal
401