Sharp MX-FN10 - Transport Section Motor and Gearbox Disassembly; PWB Section Disassembly

MX-FN10 DISASSEMBLY AND ASSEMBLY 6 – 6
2) Remove the interface cable facing part.
Remove the gear box fixing screw.
3) Remove the gear box.
(5) Transport motor assembly
1) Remove the rear cabinet upper. (See A-(5).)
2) Remove the screw, and remove the transport motor assembly.
(6) Load tray lift motor gear box
1) Remove the rear cabinet upper. (See A-(5).)
2) Remove the saddle finisher control PWB fixing part. (See C-
(2).)
3) Remove the gear box.
C. PWB section
(1) Saddle finisher control PWB
1) Remove the rear cabinet upper. (See A-(5).)
2) Remove the PWB fixing screw, and disconnect each connec-
tor, release the PWB holding pawl, and remove the PWB.