MX-FN10 PRODUCT OUTLINE 1 – 1
MX-FN10
Service Manual
[1] PRODUCT OUTLINE
1. Product outline
This unit is installed to the following machines to perform the after-process of output paper from a copier, or a fax machine. The output paper is
passed to the saddle finisher by the interface unit (MX-RBX3). Each sheet is discharged one by one by the offset function.
1) 3 kinds of auto staple functions:
There are 3 staple positions available. (One position in the front, one position at the back, 2 positions at the center)
2) Saddle stitch function: Up to 15 sheets of paper can be stapled at the center and folded into two and discharged.
3) Punch function (Option):
By installation of a puncher unit, paper can be punched to make holes for a binder. (Applicable for 64 – 128g/m
2
. OHP films cannot be
used.)
The saddle stitch finisher requires staple cartridge as a consumable part.
(Staple cartridge (About 5000 staples x 3) MX-SCX1, Staple cartridge (for saddle) (About 2000 staples x 3) AR-SC3)
2. Configuration
1) When installing this unit, the paper feed desk (MX-DEX6/DEX7) and the interface unit (MX-RBX3) must be installed together.
2) This unit cannot be installed with the finisher (MX-FNX9) simultaneously.
Applicable models MX-2600N/3100N/2600G/3100G
Paper exit system Document feeder system
Printer expansion
Memory
Authentication/Security
Application/Solution
Image send expansion
Paper feed system
To Next Page
Loading...