Sharp MX-FN10 - Punch Section Drive Section Disassembly

MX-FN10 DISASSEMBLY AND ASSEMBLY 6 – 11
3. Punch section
A. Punch drive section
(1) Punch motor removal
1) Remove the upper cover. (Remove two screws.)
2) Remove the rear blinding cover. (Remove two screws.)
3) Remove the jam process knob, the screw, and the sensor
holding part.
4) Remove the shaft reception part (front), the bearing, and the
screw, and remove the screw of the shaft reception part (rear).
5) Remove the shift.
6) Remove the screw and the motor.
a
a