Sharp MX-FN10 - Paper Transport Section Exit and Reverse Tray Disassembly

MX-FN10 DISASSEMBLY AND ASSEMBLY 6 – 10
(10) Exit Roller
1) Remove the paper pass unit.
2) Remove the bottom cover. (See (4).)
3) Remove the front cover (See (6).)
4) Remove the upper guide unit. (See (7).)
5) Remove the drawer bracket.
Remove each parts and remove the exit roller.
B. Reverse Tray Unit
(1) Reverse Flapper
1) Remove the paper pass unit.
2) Remove the reverse tray.
3) Remove each parts, and remove the reverse flapper.
C. Left Cabinet Unit
(1) Interface Transport Unit Cover Detection Sensor
1) Remove the paper pass unit.
2) Remove the reverse tray. (See B-(1).)
3) Free the lock, then remove the saddle stitch finisher.
4) Remove the left cover.
5) Disconnect the connector, and the sensor bracket. Remove
the interface transport unit cover detection sensor.
(2) Paper Pass PWB
1) Remove the paper pass unit.
2) Remove the reverse tray. (See B-(1))
3) Remove the left cover. (See C-(1).)
4) Remove allen screw, remove the interface PWB, then remove
the connector.
1
2
3
4