Test Simulations
21
DocumentSolutionsAfterSalesService
Main Sub Functions
27 13 Check the history of paper transport time between sensors.
14 Set the FSS function connection test mode.
15 Display the FSS connection status.
16 Set the FSS alert send.
17 Set the FSS paper order alert.
18 Clear the FSS paper feed retry counter.
30 1 Check the operations of the sensors in other than the paper feed section.
2 Check the operations of the sensors and the detectors in the paper feed section
and the control circuits.
40 2 Manual paper feed tray paper width sensor adjustment.
7 Set the adjustment value of the manual paper feed tray paper width sensor.
41 1 Check the operations of the document size sensor and the control circuit.
2 Adjust the document size sensor detection level.
3 Check the operations of the document size sensor and the control circuit.
43 1 Set the fusing temperature in each mode.
4 Set the fusing temperature 2 in each mode.
10 Set the postcard feed cycle
20 Perform the low-temperature, low-humidity (L/L) environment correction for the
fusing temperature setting of each paper (SIM43-01).
22 Perform the low-temperature, low-humidity (L/L) environment correction for the
fusing temperature setting of each paper (SIM43-04).
44 1 Set each correction operation function in the image forming section.
9 Display the result data of the high density process control operation.
14 Display the output level of the temperature and humidity sensor.
43 Display the identification information of the developing unit.
46 2 Adjust the copy density in the copy mode.
4 Adjust the density in the image send mode.
5 Adjust the density in the image send mode.
8 Adjust the image send mode colour balance RGB.
9 Adjust the scan image density.19Used to set the operating conditions for the
density scanning (exposure) of monochrome auto copy mode documents.
30 Adjust the resolution in the sub scanning direction in the copy mode.
32 Adjust the document background density reproducibility in the monochrome auto
copy mode.
37 Adjust the reproduction capability of monochrome mode colour.
39 Adjust the sharpness of FAX send images.
40 Adjust the FAX send image density.
41 Adjust the FAX send image density. (Normal)
42 Adjust the FAX send image density. (Fine)
43 Adjust the FAX send image density. (Super Fine)
44 Adjust the FAX send image density. (Ultra fine)
45 Adjust the FAX send image density. (600dpi).
47 Set the compression rate of copy and scan images (JPEG).
To Next Page
Loading...
Need help?
General
