Sharp MX-M264N

Test Simulations
22
DocumentSolutionsAfterSalesService
Main Sub Functions
46 60 Adjust the sharpness in the colour auto copy mode.
61 Adjust the area separation recognition level.
62 Set the operating conditions of the ACS, the area separation, the background
image process, and the auto exposure mode.
63 Adjust the density in the copy low density section.
48 1 Adjust the scan image magnification ratio (main & sub scanning direction).
5 Correction the scan image magnification ratio (in the sub scanning
direction).Scanner section.
49 1 Perform the firmware update.
3 Update the operation manual in the HDD.
5 Perform the watermark update.
50 1 Copy image position, image loss adjustment
2 Adjust the copy image position and the image loss. (This simulation is a simplified
version of SIM 50-1.)
5 Adjust the print lead edge image position. (PRINTER MODE)
6 Adjust the copy image position and the image loss.
7 Adjust the copy image position and the image loss (RSPF mode). (This simulation
is a simplified version of SIM 50-6.)RSPF
10 Adjust the black print image magnification ratio and the off-centre position. (The
adjustment is made separately for each paper feed section.)
12 Perform the scan image off-centre position adjustment. (The adjustment is made
separately for each scan mode.)
27 Perform the image loss adjustment of scanned images in the FAX or image send
mode.
28 Automatically adjust the image loss, void area, image off-centre, and image
magnification ratio.
51 2 Adjust the contact pressure on paper by the main unit and the RSPF registration.
9 Adjust the ON/OFF timing of the separation voltage.
53 6 Adjust the detection level of the RSPF document width.
7 Adjust the RSPF document size width sensor.
8 Adjust the document lead edge reference and the RSPF mode document scan
position.
55 1 Set the specifications of the engine control operations. (SOFT SW)
2 Set the specifications of the scanner control operation. (SOFT SW)
3 Set the specifications of the controller operation. (SOFT SW)
10 Set the special stamp text. (Taiwan only).
56 1 Transport data between HDD - MFP PWB SRAM/EEPROM.
2 Backup the data in the EEPROM. SD Card, and HDD (including user authentication
data and address data) to the USB memory.
3 Backup the document filing data to the USB memory.
4 Backup the JOB log data to the USB memory.