132
TROUBLESHOOTING AND MAINTENANCE
MISFEED IN THE LOWER PAPER TRAY
● Make sure that there is no misfed paper in the machine before pulling the tray out. (p.129)
●
Use the following procedure to remove misfeeds that occur in the 500-sheet paper feed unit or 2 x 500-sheet paper
feed unit.
1
Open the lower side cover.
2
Remove the misfed paper.
Be careful not to tear the
misfed paper during
removal.
3
If the misfed paper is not visible in
step 2, lift and pull out the lower paper
tray and remove the misfed paper.
Be careful not to tear the
misfed paper during
removal.
4
Replace the lower paper tray.
Push the lower paper tray in completely.
5
Close the lower side cover.
Make sure that the
misfeed message is
cleared.
MISFEED IN THE RIGHT TRAY
(when a right tray (MX-TE10) is installed)
1
Gently open the right tray cover.
2
Remove the misfed paper.
Be careful not to tear the
misfed paper during
removal.
3
Close the right tray cover.
Make sure that the misfeed message is cleared.
MX-M310.book 132 ページ ２００９年８月７日 金曜日 午後１時１０分
To Next Page
Loading...
