Sharp MX-M310N

36
3
Chapter 3
CONVENIENT COPY FUNCTIONS
This chapter explains special finishing functions and other convenient functions.
COPY FINISHING FUNCTIONS
This section explains the sort, group, and offset functions, as well as the staple sort function which is used to staple
output collated with the sort function when a finisher is installed.
SORT COPY
This function is used to collate sets of copies. Copies
can be output to the job separator tray, or the offset
tray or right tray (output tray unit) of the peripheral
finisher.
GROUP COPY
This function is used to group sets of copies by page.
Copies can be output to the job separator tray, or the
offset tray or right tray (output tray unit) of the
peripheral finisher.
OFFSET FUNCTION
Each set of copies is offset from the previous set in the
output tray, making it easy to distinguish one set from
another. (The offset function can be used in the centre
tray or in the offset tray of the finisher.)
Enabling the offset function
The offset function operates when a checkmark
appears in the [OFFSET] checkbox, which is displayed
by touching the [OUTPUT] key. (If a checkmark does
not appear, touch the checkbox.)
2
1
3
2
1
3
1
2
3
2
1
3
3
3
3
2
2
2
1
2
3
1
1
1
Offset function "ON" Offset function "OFF"
MX-M310.book 36 ページ ２００９年８月７日 金曜日 午後１時１０分