MX-M264U MX-DS16/DS17 (LOW STAND/HIGH STAND) 6 – 1
MX-M264U
Service Manual
[6] MX-DS16/DS17 (LOW STAND/HIGH STAND)
1. Unpacking
Unpack the package, and check to confirm that all the parts are
provided.
Packed parts
2. Installation
1) Attach the adjusters.
Attach the front adjusters (2 pcs.) as shown in the figure below.
2) Attach the adjuster covers.
Put the desk on the floor in the normal state, and open the
door.
Slide the adjuster covers (2 pcs.) as shown in the figure below
and attach them. Then, close the door.
3) Remove the paper tray.
Pull out the paper feed unit tray from the copier until it stops.
Lift it and remove it from the copier.
To Next Page
Loading...
