MISFEED REMOVAL
2-28
■ Misfeed in the bypass tray
1
Remove the misfed paper from the bypass
tray.
Be careful not to tear the
misfed paper during
removal.
2
If you did not find a misfeed in step 1, open
the side cover and remove the misfeed.
3
Gently close the side cover.
4
Remove tray 1 - tray 2.
Grasp the finger hold
and gently open the unit.
Pull the tray all the way
out until it stops.
5
Remove the misfed paper.
Check the paper
transfer unit inside the
tray and remove any
misfed paper.
6
Gently close paper tray 1 - tray 2.
Push the tray all the way
back in.
Make sure that the
misfeed message no
longer appears (the
normal message display
should appear).
NOTE
If a misfeed occurs during printing from the bypass
tray while paper is being loaded in tray 1 - tray 2,
push tray 1 - tray 2 back in to close it, and then pull
the tray out again.
dragonII_copy_sec.book 28 ページ ２００６年１０月１８日 水曜日 午後７時３９分
To Next Page
Loading...
