Sharp MZ-700 - Chapter 2 BASIC Programming

16
FD
For mat I Copy Ut i lit Y VX. xx
[
Funct
i on I
F
For mat
d i s k
C
Copy
d i s k
I
Bo ot
[ Co mma n d are a I
*-
Insert the floppy disk prepared into drive number 2. When "F" is pressed, the screen
becomes
as follows and the drive number is asked, so specify number 2.
*F .............................. ..
Drive No.?2
OKI
Input the drive number. In this instance, the drive
number
is 2. When the drive number is input, the
floppy disk in this drive
is initialized.
* _ .. .. .. .. .. .. .. .. . .. .. .. .. . .. . .. .. Indicates the end of floppy disk initialization and
the waiting condition for the next command.
If there is SYSTEM software in the floppy disk inserted into the floppy disk drive, the
display
is as follows and confirmation is asked.
This is Master-Disk
For ma t [Y I NI? N The meaning of display is as follows:
The floppy disk inserted into the
1>pecified drive
contains the
SYSTEM software; is initialization
and erasure
OK?
If it's OK, input Y; if it's not OK, input N.