Sharp MZ-700 - Wopen

48
WOPEN # (write open)
Opens the files for write-in.
Format:
WOPEN # <logical number>, " [<device name> :] <filename> "
Note: Only FDn, CMT, or RSn device name.
Abbreviated form:
WO. #
Explanation:
• This is a statement to prepare for file write-in; it specifies the file's logical number
and name.
• If the <device name> is omitted, processing occurs relative to the device specified
by the DEFAULT statement.
• When RS is specified for the device' name, the filename can be omitted.
Examples:
1 0 WOP EN #1," F 01 : OAT A"
..... Opens the "DATA" file defined to logical number 1 for write-in.
1 0 WOP EN # 1, "R S 1 : "
..... Output by the PRINT # command is set in RS-232C.
1 0 WOPEN
#2, "DATA"
20 FOR I =1 TO
99
30
PRI NT
#2,
40 NEXT
50
CLOSE
#2
60 END
..... 1 - 99 count is written into the file.
References:
PRINT # (page 49)
ROPEN # (page 46)
CLOSE # (page 53)
INPUT # (page 47)