Sharp MZ-700 - Init

60
INIT (Initialize)
Sets the RS mode.
Format:
INIT"RS{~ }
<monitoring code>, <initialization setting code>(,<end code>] "
Explanation:
• Sets the mode of RS-232C
<Monitoring code>
7
6
5
lID
<Initialization setting code>
5
4 3
2 o
DCD reception monitoring
DCD transmission monitoring
CTS transmission monitoring
Not used. Usually O.
RTS OFF transmission enable.
All character transmission
out monitoring.
1..- ___ p. 01 - odd parity
1
00 - non parity
anty 10 - non parity
11 - even parity
.
01 - 1 stop bit
1
00 - not used
L _______ Stop bIt 10 _ 1 + 112 stop bit
Not used. Usually 0
'-- Transmission/reception character length
{
0 -,~ bitslCHR
1
~'bitslCHR
<ending code>
Values from 0 - 255 ($00 - $FF)
11 - 2 stop bits