Sharp PC-1500 - Page 125

A ll and more about Sharp PC-1500 at http://www.PC-1500.info
\"Jh ich produces the output:
ABCDEFG
ABCDEFG
11J4~
123456
ABC DEF G 123 4 56
ABCDEFG
ABCDE FG
123456
ABCDEFG 1234
56
The LPRINT command may Ile used without an item specification. in either TEXT or
GRAPH mode:
LPRINT
Used in thi~ manner, it will caus e a Carr ia. ge Return and a single Line Fe ed . It does not,
however, reset the counters of the GRAPH mode. Thus. in the following exa mple, although the
LPR I NT statement has been used to move the pen from Point A to Poi nt B, the printer believes
itself
to be at coord inates {150, 30) and will exe • cute all subsequent commands aos if it were.
! (0, 0)
B
•
A
(150. 30)
The LPRINT statement also incorporates a USING c lause which operates in the same manner
as it does in the PRINT statement. The USING clause may only occur in an LPRINT statement
which is executed in the GRAPH mode.
C.6.
6. LCURSOR
The LCURSOR statement allows positioning of the pen in a manner analogous to the CURSOR
statement of the display. The form of the LCURSOR statement is:
LCURSOR position
{TEXT mode only)
The character position to which the pen may be moved is. of course. des:>endent on the
character si ze in effect. In general, the pen may be positioned at one space less than the maximum
for the character size. F or a lis t of the print li ne widths at each charac te r size, refer to the CSIZE
command in this section.
12 '3
Do not sale this PDF !!!