Sharp PG-D2870W - Page 23

-23
5
Click “Properties” on the “File”
menu.
6
Click the “Settings” tab, and then
click “ASCII Setup”.
7
Select the check boxes next to
“Send line ends with line feeds”,
“Echo typed characters locally”,
and “Append line feeds to
incoming line ends”, and click
“OK”.
The LAMPRESET Properties window
appears, click “OK”.
8
If a user name and/or password is
set for the projector, enter the
user name and password.
9
Send the lamp reset command
“LPRE0001”.
This command can only be sent when the
projector is in standby mode.
When “OK” is received, this indicates that the
lamp was successfully reset.
10
Close HyperTerminal.
•
•
•
5
6
7
8
9
1
0
Resetting the Lamp Timer of the Projector via LAN