Sharp PG-D2870W User Manual

-22
Resetting the Lamp Timer of the Projector via LAN
When the projector is connected to a network, you can use the communications program
to send a command to reset the lamp timer. The example below uses Windows
®
XP as the
operating system. When you use Windows Vista
®
, use other communications program
referring to the following steps, because Windows Vista
®
does not come with
HyperTerminal.
1
Click “Start” – “All Programs” –
“Accessories” – “Communica-
tions” – “HyperTerminal”.
If you do not have HyperTerminal installed,
see the operation manual of your computer.
Depending on the settings of your computer,
you may be required to enter your area code
and other details. Enter the information as
required.
2
Enter a name in the “Name” fi eld,
and click “OK”.
3
If you are required to enter the
area code, enter it in the “Area
code” fi eld. From the “Connect
using” drop-down menu, select
“TCP/IP (Winsock)”, and click
“OK”.
4
Enter the IP address of the
projector in the “Host address”
fi eld (see “TCP/IP” on the
“Network” menu of the projector),
and enter the data port of the
projector in the “Port number”
fi eld (“10002” is the factory default
setting), and click “OK”.
•
•
1
2
3
Select
“TCP/IP (Winsock)”
Select
“TCP/IP (Winsock)”
4

Sharp PG-D2870W Specifications

General

Brand	Sharp
Model	PG-D2870W
Category	Projector
Language	English