Sharp PG-D3010X User Manual

50
Adjusting the Projector Function (“PRJ-ADJ1/2” Menu)
Menu operation n Page 40
Q PRJ-ADJ1
SEL./ADJ. ENTER END
Auto Power Off On
Auto Restart On
Speaker On
OffKeylock
9600bps
System Lock
RS-232C
Fan Mode Normal
Disable
Auto Sync On
Pict. SCR PRJ-ADJ1SIG PRJ2 Net.
1
2
3
4
5
7
6
8
1
Auto Sync (Auto Sync
Adjustment)
Selectable
items
Description
On Auto Sync adjustment will occur when
the projector is turned on or when the
input signals are switched, when
connected to a computer.
Off Auto Sync adjustment is not
automatically performed.
Auto Sync adjustment is also performed by
pressing AUTO SYNC.
The Auto Sync adjustment may take some
time to complete, depending on the image of
the computer connected to the projector.
When the optimum image cannot be achieved
with Auto Sync adjustment, use manual
adjustments. (See page
45.)
•
•
•
Note
2
Auto Power Off Function
Selectable
items
Description
On When no input signal is detected for
more than 15 minutes, the projector will
automatically enter Standby mode.
Off The Auto Power Off function will be
disabled.
When the Auto Power Off function is set to
“On”, 5 minutes before the projector enters
Standby mode, the message “Enter STANDBY
mode in X min.” will appear on the screen to
indicate the remaining minutes.
•
Note
Q PRJ-ADJ2
Pict. SCR PRJ-ADJ2SIG Net.
SEL./ADJ. ENTER END
COMPUTER2 Select
DLP
®
Link
TM
h
Off
Monitor Output
FUNCTION Button Input Search
STANDBY Mode Quick Start
0 min0Lamp Timer(Life) 100%
DLP
®
Link
TM
Invert
Quick Start Menu On
PRJ1
All Reset
9
0
3
Auto Restart Function
Selectable
items
Description
On
If the power cord is unplugged from the
outlet or the breaker switch is turned off
when the projector is on, then the
projector automatically turns on when
the power cord is plugged into the AC
outlet or the breaker switch is turned on.
Off The projector does not turn on
automatically when the power cord is
plugged into the AC outlet or the
breaker switch is turned on.
4
Speaker Setting
Selectable
items
Description
On The audio signal is output from the
internal speaker.
Off The audio signal is not output from the
internal speaker.
5
Selecting the Transmission
Speed (RS-
232C)
Make sure that both the projector and
computer are set for the same baud rate.
Selectable
items
Description
9600bps
38400bps
115200 bps
Transmission speed is slow.
Transmission speed is rapid.

Sharp PG-D3010X Specifications

General

Brand	Sharp
Model	PG-D3010X
Category	Projector
Language	English