Sharp PG-LW3000 User Manual

15
Easy Start
1 After the projector turns on, the Setup Guide appears.
(When “Setup Guide” is set to “On”. See page 49.)
2 Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.
3 After adjusting the focus, height (angle) and picture size, press ENTER to finish the
Setup Guide.
4. Adjust the projected image with the Setup Guide
_P. 26
Correcting trapezoidal distortion using Keystone Correction.
On the remote control
Shrinks
upper side.
Shrinks
lower side.
5. Correct trapezoidal distortion
_P. 28
Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode,
and use < / > to select the audio input terminal.
INPUT list
1 COMPUTER1
INPUT Audio
2 MONITOR OUT
HDMI
H
On the
projector
On the remote
control
On the
projector
On the remote
control
6. Select the Input mode
_P. 29
7. Turn the computer on
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confirmation message is displayed to put the projector into
Standby mode.
On-screen display
On the
projector
On the remote
control
8. Turn the power off
_P. 25

Sharp PG-LW3000 Specifications

General

Brand	Sharp
Model	PG-LW3000
Category	Projector
Language	English