ii
IMPORTANT
•  For  your assistance  in  reporting  the  loss 
or  theft  of  your  Projector,  please  record 
the Model and Serial Number located on 
the bottom of the projector and retain this 
information.
•  Before  recycling  the  packag ing,  please 
ensure  that  you  have  checked  the  con-
tents of the carton thoroughly against the 
list of “Supplied accessories” on page 3.
Model No.:
Serial No.:
SPECIAL NOTE FOR USERS IN THE U.K.
The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating 
a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse 
marked 
 or   and of the same rating as above, which is also indicated on the pin face 
of the plug, must be used.
Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse 
cover fitted.
In the unlikely event of the socket outlet in your home not being compatible with the plug 
supplied, cut off the mains plug and fit an appropriate type.
DANGER:
The fuse from the cut-off plug should be removed and the cut-off plug destroyed immedi-
ately and disposed of in a safe manner.
Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket 
outlet, as a serious electric shock may occur.
To fit an appropriate plug to the mains lead, follow the instructions below:
WARNING:
THIS APPARATUS MUST BE EARTHED.
IMPORTANT:
The wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow  : Earth
Blue  : Neutral
Brown  : Live
As the colours of the wires in the mains lead of this apparatus may not correspond with 
the coloured markings identifying the terminals in your plug proceed as follows:
•
  The wire which is coloured green-and-yellow must be connected to the terminal in the 
plug which is marked by the letter E or by the safety earth symbol 
 or coloured green 
or green-and-yellow.
•
  The wire  which  is  coloured  blue  must  be connected  to  the  terminal  which  is  marked 
with the letter N or coloured black.
•
  The wire which is coloured brown must be connected to the terminal which is marked 
with the letter L or coloured red.
IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.