PLASMACLUSTER OPERATION
The Plasmacluster Ion generator inside the air
conditioner will release positive and negative
plsmcluster ions into the room.
Approximately the same number of positive and
negative ions released into the air will help to
reduce some irborne mold.
1
During operation, press the
PLASMACLUSTER button.
• The remote control will display “ ”.
• The blue PLASMACLUSTER lamp on the
unit will light up.
TO CANCEL
Press the PLASMACLUSTER button gin.
• The PLASMACLUSTER lamp on the unit will turn
off.
NOTE:
• Use of the PLASMACLUSTER operation will be
memorised, and it will be activated the next time
you turn on the air conditioner.
• To turn off the PLASMACLUSTER lamp, press the
DISPLAY button.
• To perform the PLASMACLUSTER operation
without accompanying heat, cool or dry mode,
press the PLASMACLUSTER button while the unit
is not operating. The mode symbol of the remote
control will go off and the fan speed can not be set
to AUTO.
SELF CLEAN OPERATION
SELF CLEAN operation using plasmacluster ions
helps to reduce the growth of mold fungus and
to dry the inside of the ir conditioner unit. It is
recommended to utilise the operation at seasonal
chnge over.
Note, Mold fungus already in existence can not be
eliminated by this operation.
1
Press the SELF CLEAN button when the
unit is not operting.
• The remote control displays “ ”.
• The red OPERATION lamp ( ), the
green SELF CLEAN lamp (
) and the blue
PLASMACLUSTER lamp on the unit will light up.
• The unit will stop operation after forty minutes.
TO CANCEL
Press the SELF CLEAN button.
Alternatively, turn the unit off by pressing the ON/
OFF button.
• The red OPERATION lamp (
), the green SELF
CLEAN lamp ( ) and the blue PLASMACLUSTER
lamp on the unit will turn off.
NOTE:
• You cannot set the temperature, fan speed, air ow
direction or timer setting during the SELF CLEAN
operation.
To Next Page
Loading...
Need help?
General
