Sharp Plasmacluster AE-X12JJ User Manual

6
BASIC OPERATION
TIPS ABOUT AUTO MODE
In the AUTO mode, the temperature setting
and mode are automatically selected accord-
ing to the room temperature and outdoor
temperature when the unit is turned on.
Modes and Temperature Settings
The gures in ( ) are temperature settings
During operation, if the outdoor temperature
changes, the temperature settings will auto-
matically slide as shown in the chart.
MODE CHANGEOVER
During seasons when you need COOLING
at daytime and HEATING at night, or if the
room temperature should become extremely
higher than the temperature setting, due to
supplementary heating equipment, the mode
will automatically switch between HEAT and
COOL mode to keep the room temperature
comfortable.
(Example: 1°C higher)
C
(Example: 2°C lower)
C
29
21
2818100 34
(°C)
(°C)
Cool
(24°C)
Cool
(25°C)
Heat
(22°C)
Dry
( )
Heat
(23°C)
Heat
(24°C)
Cool
(26°C)
outdoor
temp.
indoor temp.
Room Temp.
-2°C
2
5
3
1
4
CLEAN
FAN
MODE
SET/C
1h
DISPLAY
1
Press the MODE button to select the
opertion mode.
AUTO HEAT COOL DRY
2
Press the ON/OFF button to start
opertion.
• The red OPERATION lamp ( ) on the unit
will light.
3
Press the THERMOSTAT button to set the
desired temperture.
AUTO/DRY MODE
• The temperature can be changed in 1°C incre-
ments within the range of 2°C higher to 2°C
lower from the temperature automatically deter-
mined by the air conditioner.
COOL/HEAT MODE
• The temperature can be set within the range
of 18 to 32°C.
4
Press the FAN button to set the desired
fn speed.
AUTO SOFT LOW HIGH
• In the DRY mode, the fan speed is preset to
AUTO and cannot be changed.
5
To turn off the unit, press the ON/OFF
button gin.
• The red OPERATION lamp ( ) on the unit
will turn off.
AY-XP9JJ_en.indd 6 07.6.22 7:50:46 AM

Sharp Plasmacluster AE-X12JJ Specifications

General

Brand	Sharp
Model	Plasmacluster AE-X12JJ
Category	Air Conditioner
Language	English