Sharp Plasmacluster AE-X12JJ User Manual

5
T h e ai r pu r if y i n g f il t e rs ar e pa c ke d as
ccessories of this unit. During opertion of
the ir conditioner, the lters remove dust nd
tobacco smoke from the air and discharge clean
ir.
1
Tke out the ir lters.
1
Open the front panel.
2
Push the air lters up slightly to unlock them.
3
Pull the air lters down to remove them.
2
Set the ir purifying lter under the lter
stoppers locted on the ir lter.
3
Reinstll the ir lters.
1
Reinstall the air lters in the original posi
-
tions.
2
Close the front panel.
3
Push the arrow-marked areas of the panel
rmly to lock it in place.
Precautions:
• The lters are sealed in a plastic bag to keep their
dust collection effect.
Do not open the bag until using the filters.
(Otherwise the lter life may be reduced.)
• Do not expose the filters to direct sunlight.
(Otherwise they may deteriorate.)
TIPS ON SAVING ENERGY
Below are some simple ways to save energy when
you use your ir conditioner.
SET THE CORRECT TEMPERATURE
• Setting the thermostat 1°C higher than the desired
temperature in the COOL mode and 2°C lower in
the HEAT mode will save approximately 10 percent
in power consumption.
• Setting the temperature lower than necessary
during cooling operation will result in increased
power consumption.
BLOCK DIREC T SUNL I GHT AND PREVENT
DRAFTS
• Blocking direct sunlight during cooling operation will
reduce power consumption.
• Close the windows and doors during cooling and
heating operations.
SET PROPER AIR FLOW DIRECTION TO OBTAIN
THE BEST AIR CIRCULATION
KEEP THE FILTER CLEAN TO ENSURE THE MOST
EFFICIENT OPERATION
MAKE THE MOST OF THE TIMER OFF FUNCTION
DISCONNECT THE POWER CORD, OR TURN OFF
AT THE CIRCUIT BREAKER, WHEN THE UNIT IS
NOT USED FOR AN EXTENDED PERIOD OF TIME
• The indoor unit still consumes a small amount of
power when it is not operating.
AUXILIARY MODE
Use this mode when the remote control is not
vilble.
TO TURN ON
Lift the open panel of the indoor unit and press
the AUX. button.
• The red OPERATION lamp (
) on the unit will
light and the unit will start operating in the AUTO
mode.
• The fan speed and temperature setting are set to
AUTO.
TO TURN OFF
Press the AUX. button gin.
• The red OPERATION lamp (
) on the unit will
turn off.
NOTE:
• If the AUX. button is pressed during normal
operation, the unit will turn off.
SETTING AIR PURIFYING
FILTER
Filter stopper
Air purifying lter
Air lter
3
2
1
1
3
2
AUX
AY-XP9JJ_en.indd 5 07.6.22 7:50:46 AM

Sharp Plasmacluster AE-X12JJ Specifications

General

Brand	Sharp
Model	Plasmacluster AE-X12JJ
Category	Air Conditioner
Language	English