MAINTENANCE AFTER AIR
CONDITIONER SEASON
1
Operate the unit in the SELF CLEAN
m o d e t o a l l o w t h e m e c h a n i s m t o
thoroughly dry.
2
Stop the opertion nd unplug the unit.
Turn off the circuit breaker, if you have
one exclusively for the ir conditioner.
3
Clen the lters, then reinstll them.
MAINTENANCE BEFORE AIR
CONDITIONER SEASON
1
Mke sure tht the ir lters re not dirty.
2
Make sure that nothing obstructs the air
inlet or outlet.
CHANGING THE AIR PURIFYING
FILTER
The lters should be changed every 3 ~ 6 months
1
Remove the ir lters.
2
Chnge the ir purifying lters.
1
Take off the old air purifying lters from the
air lters.
2
Set the new air purifying lters, under the
lter stoppers located on the air lters.
3
Reinstll the ir lters.
NOTE:
• Dirty air purifying lters are not washable for reuse.
New lters are available at your nearest dealer.
Replacement lter: Type AZ-F900F
Disposal of Filters
Please dispose of replaced lters according to the
local disposal laws and regulations.
AIR PURIFYING lter materials
Filter:Polypropylene
Frame:Polyester
MAINTENANCE
Be sure to disconnect the power cord from the
wall outlet or turn off the circuit breaker before
performing ny mintennce.
CLEANING THE FILTERS
The air lters should be cleaned every two weeks.
1
Turn off the unit.
2
Remove the lters.
1
Lift the front panel.
2
Push the air lters up slightly to unlock them.
3
Pull the air lters down to remove them.
3
Tke off the ir purifying lters from the
ir lters.
4
Clen the lters.
Use a vacuum cleaner to remove dust. If the
lters are dirty, wash them with warm water and
a mild detergent. Dry lters in the shade before
reinstalling.
5
Reinstll the ir purifying lters.
6
Reinstll the lters.
1
Reinstall the lters in the original positions.
2
Close the front panel.
3
Push the arrow-marked areas of the panel
rmly to
lock it in place.
CLEANING THE UNIT AND THE
REMOTE CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them. It can
cause electrical shock or equipment damage.
• Do not use hot water, thinner, abrasive powders or
strong solvents.
Filter stopper