Sharp PN-70HC1E - Specifications; Mounting Precautions (for SHARP Dealers and Service Engineers)

8
E
• Wheninstalling,removingormovingthemonitor,ensurethatthisiscarriedoutbyatleast3people.
• Besuretouseawall-mountbracketdesignedordesignatedformountingthemonitor.
• Thismonitorisdesignedtobeinstalledonaconcretewallorpillar.Reinforcedworkmightbenecessaryforsomematerials
suchasplaster/thinplasticboard/woodbeforestartinginstallation.
• Thismonitorandbracketmustbeinstalledonawallwhichcanendureatleast4timesormoretheweightofthemonitor.
Installbythemostsuitablemethodforthematerialandthestructure.
• ToattachaVESA-compliantmountingbracket,useM6screwsthatare5/16inch(8mm)to3/8inch(10mm)longerthanthe
thicknessofthemountingbracket.
Screws (M6)
Mounting bracket
Monitor mounting
5/16 - 3/8 inch (8-10 mm)
• Donotuseanimpactdriver.
• Whenmovingthemonitor,besuretoholdthepartsmarkedby
below.Donotgraspthescreenortray.Thismaycause
productdamage,failure,orinjury.
• Ifyouneedtotemporarilyplacethemonitoronatableorothersurfaceduringinstallation,spreadathicksoftclothonthe
tabletopreventdamagetothescreenandtable.
• Priortorepackingorremoval,removethetray.
• Aftermounting,pleasecarefullyensurethemonitorissecure,andnotabletocomeloosefromthewallormount.
• Donotuseanyscrewholesotherthanthoseformountingbrackets,locatedontherearofthemonitor,forinstallation.
Model PN-70HC1E
Power requirement AC100-240V,4.5A,50/60Hz
Operating temperature
*
1
*
2
41°Fto95°F(5°Cto35°C)
Operating humidity
*
2
20% to 80% (no condensation)
Power consumption
*
3
400W
Dimensions inch (mm)
(excluding protrusions)
Approx.64-1/8(W)x3-15/16(D)x39(H)(1629 x 100 x 990)
Weight lbs.(kg)
Approx. 119.0 (54)
*1 TemperatureconditionmaychangewhenusingthemonitortogetherwiththeoptionalequipmentsrecommendedbySHARP.Insuch
cases,pleasecheckthetemperatureconditionspecifiedbytheoptionalequipments.
*2 Inaddition,checktherequirementsofthecomputerandotherdevicestobeconnected,andmakesurethatallrequirementsaresatisfied.
*3 Whenanoptionisinstalledintheexpansionslot.Whennotinstalled,295W.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
withoutpriornotice.Theperformancespecificationfiguresindicatedarenominalvaluesofproductionunits.Theremaybesomedeviationsfrom
these values in individual units.
Mounting Precautions (For SHARP dealers and service engineers)
Specifications