Sharp PN-70HC1E - Supplied Components; Preparing the Remote Control Unit

5
E
ENGLISH
Supplied Components
Preparing the Remote Control Unit
1. Placeyourfingeronthepartmarkedwiththe▲,and
then pull the cover off.
2. See the instructions in the compartment and put in the
batteries (R03 or LR03 (“AAA” size) x 2) with their plus
(+) and minus (-) sides oriented correctly.
3. Close the cover.
Ifanycomponentshouldbemissing,pleasecontactyourdealer.

Liquid Crystal Display Monitor: 1

Remote control unit: 1

Cableclamp(affixingtype):3

Power cord

Remotecontrolunitbattery:2

CD-ROM(UtilityDiskforWindows):1

Setup Manual (this manual): 1

Touch pen: 2

Tray: 1

Tray mounting screws (M3x15): 5

USBcable:1

Cover SHARP logo: 1
Place this sticker onto the SHARP logo to cover the logo.

WirelessAdapter:1
* SHARP Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
 Donotdisposeofbatteriesinhouseholdwaste.Followthedisposalinstructionsforyourarea.