Sharp PN-B401 - RS-232 C Command Reference; Commands for Power and Input Selection

39
E
RS-232C command table
How to read the command table
Command: Commandeld(Seepage35.)
Direction: W Whenthe“Parameter”issetintheparametereld(seepage35),thecommandfunctionsasdescribed
under“Control/ResponseContents”.
 R Thereturnedvalueindicatedunder“Reply”canbeobtainedbysetting“????”,“
?”or“???+”
(repeatercontrol)intheparametereld.(Seepage35.)
Parameter: Parametereld(Seepage35.)
Reply: Response(Returnedvalue)
*: WhenPOWERSAVEMODEissettoOFF:
 “●/○”:Indicatesacommandwhichcanbeusedinstandbymodeorwhenthepowerison.
 “–” :Indicatesacommandwhichcanbeusedwhenthepowerison.Cannotbeusedinstandbymode.
 WhenPOWERSAVEMODEissettoON:
 “●” :Indicatesacommandwhichcanbeusedinstandbymodeorwhenthepowerison.
 “○/–”:Indicatesacommandwhichcanbeusedwhenthepowerison.Cannotbeusedinstandbymode.
Power control/Input mode selection
Function
Command Direction
Parameter Reply Control/Response contents *
POWERCONTROL POWR W 0 Switchestostandbymode.
●
1 Returnsfromstandbymode.
R 0 Standbymode
1 Normalmode
2 Inputsignalwaitingmode
INPUTMODESELECTION INPS W 0 Togglechangeforinputmode.TerminalsnotselectedinINPUTSELECT
cannotbeselected.
2 D-SUB[RGB]
“ERR”whenotherthanRGBisselectedforD-SUBofINPUTSELECT.
3 D-SUB[COMPONENT]
“ERR”whenotherthanCOMPONENTisselectedforD-SUBofINPUT
SELECT.
10 HDMI1
13 HDMI2
14 DisplayPort
21 OPTION
“ERR”whennothingisattachedintheexpansionslot.
24 APPLICATION
R 2 D-SUB[RGB]
3 D-SUB[COMPONENT]
10 HDMI1
13 HDMI2
14 DisplayPort
21 OPTION
24 APPLICATION
SCREEN menu
Function
Command Direction
Parameter Reply Control/Response contents *
Checktheresolution
(otherthanD-SUB[COMPONENT])
PXCK R - Returnscurrentresolutionintheformofhhh,vvv.
○
Controlling the Monitor with a computer (RS-232C)