Sharp PN-HB851

Confidential
For use by Sharp authorized dealers
and distributors only.
Not for general distribution.
PN-HB851/HB751/HB651/HM851/HM751/HM651 Installation Guidelines <Rev1.0> April. 2019
Mounting bracket for monitor (M6 screw)
Length of screw : 8mm-10mm
Screw (M6)
Mounting bracket
Rear cover of monitor
Captive
nut for
fixing
-Please take attention to following items for using screw holes behind IDP.
1) Please use more than 4 mounting screws to fix the monitor.
2) Please use symmetrical screw holes across the center line.
*It can cause malfunction or deformation of the monitor to use screw holes asymmetrically.
3)Please use a mounting bracket having not more than 7.5mm hole diameter.
*Oversize of hole diameter can cause unfastening of the captive nut by the mounting screw.
4)Please use screws being correct length written in operation material of monitor.
*Over length of screw can cause unfastening of the captive nut by the mounting screw.
5)Please take measures by all means to prevent the screws loosening.
(For example : using screws with washer)
6) Please tighten screws hard with not more than 3N*m strength.
(Tightening torque: 3N*m )
27
PN-HB751/HM751
VESA 600 x 400
PN-HB651/HM651
VESA 400 x 400
PN-HB851/HM851
VESA 600 x 400
VESA hole
VESA hole
VESA hole
3.5 Attachment precaution