Sharp PN-HS431

15
E
Caution
• Turn on the monitor rst before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button o󰀨 and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.
Turning on the main power
Main power switch
O󰀨 mode, when main power is o󰀨.
Caution
• The main power must be turned on/o󰀨 with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/o󰀨 while the main power switch is on.
• For a complete electrical disconnection, pull out the main
plug.
Turning Power On/O󰀨
Turning power on/o󰀨
Press the POWER button to turn the power ON/OFF.
You can also turn the power ON/OFF by pressing the
MONITOR ON button/MONITOR OFF button on the remote
control unit.
[Rear view] [Front view]
POWER button
Power LED
Status Status of the monitor
Green lit Power on
Orange lit Power o󰀨 (Standby state*)
Green ashing Input signal waiting state
* Standby mode when POWER SAVE MODE is set to ON.
Networked standby mode when POWER SAVE MODE is set
to OFF. Networked standby mode allows the monitor to be
turned on via network (LAN, RS-232C, and HDMI CEC).
TIPS
• When the main power switch is o󰀨, the monitor cannot be
turned on.
• If the monitor is in the input signal waiting state and you
press the POWER button or MONITOR OFF button, the
monitor enters standby state.
• Setting the SCHEDULE ashes the power LED alternately
in red and orange in standby state.