Sharp PN-V602A - Page 56

56
E
Specications
n
PN-ZR01 (optional) Product Specications
Model PN-ZR01
Remote control sensor box dimensions inch (mm)
Approx. 1-3/8(W)x7/8(D)x5-1/8(H)(34.2 x 23 x 130)
Remote control sensor box weight lbs. (kg)
Approx. 0.220 (0.1)
n
Dimensional Drawings
Note that the values shown are approximate values.
Unit: inch [mm]
52-5/8 [1335.9]
Opening width (52-5/16 [1329.4])
Opening height (29-7/16 [747.7])
29-11/16 [754.2]
7-7/8 [200]
5-7/8
[149.3]
52-5/8 [1335.9]
3-5/8
[92.3]
7-7/8
[200]
7-7/8
[200]
VESA holes *
3-15/16
[100]
3-15/16
[100]
Whenmountingthemonitor,besuretouseawall-mountbracketthatcomplieswiththeVESA-compatiblemountingmethod.
SHARPrecommendsusingM6screwsandtightenthescrews.
Notethatscrewholedepthofthemonitoris3/8inch(10mm).Loosemountingmaycausetheproducttofall,resultinginserious
personalinjuriesaswellasdamagetotheproduct.Thescrewandholeshouldcometogetherwithover5/16inch(8mm)length
ofthread.UseabracketwhichhasbeenapprovedforUL1678standard,andwhichcanendureatleast4timesormorethe
weight of the monitor.
n
Power management
ThismonitorconformstoVESADPMSandDVIDMPM.Bothyourvideocardandcomputermustsupportthesamestandardin
order for the monitor’s power management function to work.
DPMS:DisplayPowerManagementSignaling
DPMS Screen
Power
consumption*
1
Hsync Vsync
ONSTATE Display 510W Yes Yes
STANDBY
No
display
1.0W*
2
No Yes
SUSPEND Yes No
OFFSTATE No No
DMPM:DigitalMonitorPowerManagement
DMPM Screen
Power
consumption*
1
Monitor ON Display 510W
ActiveOFF No display 1.0W*
2
*1 WhenPN-ZR01(optional),orPN-ZB02(optional)isnotconnected.
*2 WhenAUTOINPUTCHANGEissettoOFF.
n
POWER LIMITED (See page 24.)
MODE Power consumption
MODE2 195W
MODE1 310W
OFF 510W
Settoensuremaximumpowerconsumption.(Seepage55.)
n
DDC (plug and play)
ThemonitorsupportstheVESADDC(DisplayDataChannel)standard.
DDCisasignalstandardforplugandplaybetweenmonitorsandcomputers.Informationaboutresolutionandotherparameters
isexchangedbetweenthetwo.ThisfunctioncanbeusedifthecomputersupportsDDCandithasbeenconguredtodetect
plug-and-playmonitors.
ThereareseveraltypesofDDC,dependingonthecommunicationmethodused.ThismonitorsupportsDDC2B.