Sharp PRO-60X5FD - Table 1. Concrete flashing pattern (Error standby); Table 2. Concrete flashing pattern (Verup, etc.)

PRO-60/70X5FD
6 – 2
Table 1. Concrete flashing pattern (Error standby)
*2: They depend on the system. Power supply error is defined from product to product.
*3: For details, refer to ERROR STANDBY CAUSE on the adjustment process screen.
Table 2. Concrete flashing pattern (Verup, etc.)
*4: If the boot section is abnormal, there is no flashing (flashing impossible).
3. New method
Item
Outline display Detail display
Cause
Slow flashing Fast flashing Slow flashing Fast flashing
Inverter/Lamp system
failure
Flashes once None Flashes once Flashes once Lamp error
Power PWB failure
(Power failure, etc.)
Flashes twice None Flashes twice Flashes once Power supply error 1 (*2) AC_DET error
Flashes twice Power supply error 2 (*2) UR+13V error
Flashes 3 times Power supply error 3 (*2) D3.3V error
Flashes 5 times Panel power supply error
Main PWB failure
(Communication fail-
ure, etc.)
Flashes 3 times None Flashes 3 times Flashes once Initial communication error
Flashes twice Start-up confirmation communication error
Flashes 3 times Regular communication error
Flashes 5 times Other communication error
Others Flashes 4 times None Flashes 4 times Flashes once Temperature error
Flashes twice Sync error
Flashes 3 times Notification from the main microcomputer (*3)
Item Display Note
Ver UP executing Flashes continuously (1 sec cycle) The flash only when rewriting the sub microcomputer.
Ver UP succeeded Flashes continuously (4 sec cycle) The flash only when rewriting the sub microcomputer.
ROM data failure Flashes continuously (400 msec cycle, On period: 100 msec) Start-up after failing version upgrade (*4)
• Flashing during Verup
• Flashing when completing Verup
PowerLED
1600ms
300ms
100ms
400ms
400ms
1600ms
Power LED
500ms
500ms
Power LED
2000ms
2000ms