Sharp QT-37H - PACKING METHOD (QT-37 E Only)

ORES Yi aT 4 =
PACKING METHOD (QT-37E Only)
PACKING PROCEDURE
Setting positions of every switch and knob.
The beat cancel switch is set at A position.
The volume control knob is set at min position.
The balance control knob is set at center position.
The tape selector switch is set at NORMAL and OFF position.
The function selector knob is set at tape position.
The FM Mode selector knob is set at stereo position.
The band selector knob is set at MW position.
The digital tape counter is set at 000 position.
The tuning control knob is set at start point O position.
The mechanical button are set at disengeged position.
Polyethylene Bag,
Unit
SSAKHO171AFZZ
Packing Add. (Top)
SPAKA1058AFZZ
Packing Add.
(Bottom)
SPAKA1056AFZZ
Polyethylene Bag, [
Speaker
SSAKHO172AEZZ E
Polyethylene Bag,
Operation Manual
SSAKAO0104AFZZ
AC Power Supply Cord
QACCB0057 AFO9 -
Plug, Erasing
OPLGZ0152AFZZ
Cassette Tape
RTPEKONO1AFZ2Z
Operation Manual
TINSEO892AF ZZ
Caution Label
TCAUHOO56AGZZ
Warranty Card
TGANE1117AFZZ
Packing Case
SPAKC2463AFZZ
—~24—