Need help?Do you have a question about the Sharp GF-800Z and is the answer not in the manual?
Power| AC power source voltage | 110V - 127V and 220 - 240V |
|---|---|
| DC power source voltage | 15V |
| Frequency | 50/60Hz |
Output Power| PMPO output power | 52W (26W + 26W) |
|---|---|
| MPO output power | 40W (20W + 20W) |
| RMS output power | 26W (13W + 13W) |
Tape Recorder Specifications| frequency response for normal tape | 30Hz — 14, 000Hz |
|---|---|
| frequency response for CrO2 tape | 30Hz - 16, 000Hz |
| frequency response for metal tape | 30Hz - 17, 000Hz |
| signal/noise ratio for Deck 1 playback | 55 dB |
| signal/noise ratio for Deck 2 recording | 50 dB |
Impedance| external mic input impedance | 600 ohms |
|---|---|
| phono/line in input impedance | 50 kohms/50 kohms |
| loaded impedance for headphones | 8 ohms — 32 ohms |
| loaded impedance for external speakers | 8 ohms — 16 ohms |
| line out impedance | 0.6V/50 kohms |
Radio Specifications| AM frequency range | 526.5 kHz - 1606.5 kHz |
|---|---|
| SW1 frequency range | 2.3 MHz - 7.3 MHz |
| SW2 frequency range | 7.3 MHz - 22 MHz |
| FM frequency range | 87.6 MHz - 108 MHz |
Speaker Specifications| woofer size | 16 cm (6-1/2") |
|---|---|
| tweeter count | 2 |
| speaker impedance | 8 ohms |
| maximum input | 26W |
Weight and Dimensions| width | 681 mm (26-13/16") |
|---|---|
| height | 225 mm (8-7/8") |
| depth | 210 mm (8-1/4") |
| weight | 8.8 kg (19.4 lbs.) without batteries |
Identifies controls related to radio functions.
Identifies controls for the second cassette deck.
How to operate the unit using batteries.
Important safety and usage precautions for batteries.
Steps to connect the unit to AC power.
How to operate the main power switch.
How to adjust sound equalization for different frequencies.
Steps to load a cassette tape into the deck.
How to set tape type selectors for optimal playback/recording.
Steps for locating selections using APLD.
Steps for pausing playback after a set number of selections.
Steps to record radio broadcasts.
Instructions for copying tapes from Deck 1 to Deck 2.
Steps to record radio programs using the timer.
Steps to playback tapes using the timer.
How to clean tape heads and mechanical components.
To Next Page
