Name: Sharp GF-800Z
Brand: Sharp
Rating: 5 (1 reviews)

To Next Page

To Previous Page

CASSETTE PLAYBACK

• Since treble is emphasised on tapes recorded with Dolby NR

system, for playback of such tapes with this unit, lowering

treble slightly with the GRAPHIC EQUALIZER controls

makes for easier listening.

• When playing a tape with Deck 1, set the DUBBING SPEED

selector switch to the NORMAL position. At the HIGH posi-

tion, the equalizer circuit for high speed operation is activated

and the high range will be lowered.

Load a pre-recorded cassette into the cassette compartment

of Deck 1 and/or Deck 2 and set the tape selector switches

(refer to instructions on page 11).

Refer to the instructions on page 8.

Press the TAPE button of the FUNCTION selector.

INDIVIDUAL PLAYBACK |

Set the CONT PLAY switch to the position.

Press the • PLAY button of Deck 1 or Deck 2 to begin play-

back.

SEQUENTIAL PLAYBACK |

Sequential playback starts with Deck 1 first and then Deck 2,

or vice versa can be performed.

Press the PLAY button of the Deck to be played first.

Then, the first Deck will start.

Set the CONT PLAY switch to the position.

Press the • PLAY button of the Deck to be played finally.

(Playback of the Cassette Deck to be played finally will

begin when the Cassette Deck played first has ended)

[SIMULTANEOUS PLAYBACK[

Set the CONT PLAY switch to the[1]&/or[2]position.

Press the • PLAY buttons of Deck 1 and Deck 2 simultane-

ously.

The stereo audio reproduction from both cassettes will be

mixed and reproduced concurrently from the speakers.

• Adjust volume and sound quality (refer to instructions on page

9.)

TO INTERRUPT PLAYBACK

Press the II PAUSE button to discontinue playback temporarily.

The tape will stop at the point where this button is pressed. The

playback will be resumed from this point when the II PAUSE

button is pressed again.

HOW TO STOP THE TAPE

To stop the tape when the unit is in the recording, playback, fast

forward, rewind or APLD mode, press the

button.

FULL AUTO STOP SYSTEM

When the tape is reached to the end while the unit is in the

recording, playback, fast forward, rewind mode, the full auto

stop system is activated, and it automatically set the deck to the

stop mode.

• The auto-stop system may not be functioned when the unit is

battery powered and the batteries are weak.

Questions and Answers:

Need help?

Do you have a question about the Sharp GF-800Z and is the answer not in the manual?

Sharp GF-800Z Specifications

Power

AC power source voltage	110V - 127V and 220 - 240V
DC power source voltage	15V
Frequency	50/60Hz

Output Power

PMPO output power	52W (26W + 26W)
MPO output power	40W (20W + 20W)
RMS output power	26W (13W + 13W)

Tape Recorder Specifications

frequency response for normal tape	30Hz — 14, 000Hz
frequency response for CrO2 tape	30Hz - 16, 000Hz
frequency response for metal tape	30Hz - 17, 000Hz
signal/noise ratio for Deck 1 playback	55 dB
signal/noise ratio for Deck 2 recording	50 dB

Impedance

external mic input impedance	600 ohms
phono/line in input impedance	50 kohms/50 kohms
loaded impedance for headphones	8 ohms — 32 ohms
loaded impedance for external speakers	8 ohms — 16 ohms
line out impedance	0.6V/50 kohms

Radio Specifications