Sharp QW-S12I492X-EN - Chapter-9: Failure Codes and What to Do İn Case of Failure

EN-22
CHAPTER -9: FAILURE CODES AND WHAT TO DO IN CASE OF
FAILURE
ERROR CODE
ERROR
DESCRIPTION
CONTROL
P1 P2 P3 P4
Inadequate water
supply
• Make sure the water input tap is totally
open and that there is no water cut.
• Close the water input tap, separate the
water input hose from the tap and clean the
lter at the connection end of the hose.
• Restart your machine, contact the service if
the error resumes.
Error of continuous
water input
• Close the tap.
• Contact service.
The waste water in the
machine cannot be
discharged.
• Water discharge hose is clogged.
• The lters of your machine might be
clogged.
• Power off-on your machine and activate the
program cancellation command.
• If the error continues, contact the service.
Heater error • Contact service.
Alarm is active against
water overow
• Power off your machine and close the tap.
• Contact service.
Faulty electronic card • Contact service.
If one of the program monitor lights is on and start/Pause light is on and off,
Your machine’s door is open, shut the door.
If the programme won’t start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine door.
• Be sure that you switched off the machine by pressing the Power On / Off button.
• Be sure that the water inlet lter and the machine lters are not clogged.
If the lamps “Wash/Dry” and “End” keep ashing
• The water overow alarm is active
• Turn off your tap and contact the Sharp helpdesk.
If the control lamps won’t go out after a wash operation
Check if the Power On/Off button is released.
If detergent residues are left in the detergent compartment
Detergent has been added when the detergent compartment was wet.
If water is left inside the machine at the end of the programme
• The water drain hose is clogged or twisted.
• The lters are clogged.
• The programme is not nished yet.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program can be on standby mode.
If shaking and hitting noises are heard during a wash operation
• Dishes placed incorrectly.
• Spray arm hitting the dishes.