Sharp SDW6747GS - Error Codes; Appliance Error Code Meanings; Drain Hose Installation Methods

20
ERROR CODES
When some malfunctions occur, the appliance will display error codes to warn you:
CODES MEANINGS POSSIBLE CAUSES
E1 • Longer inlet time • Faucet is not opened, or water intake is restricted, or water pressure is
too low
• Improper or Incomplete Draining • Drain Hose is extended more than 10 ft from Dishwasher
• Drain Hose is not properly looped underneath sink, or not installed
with Air Gap
• Drain Hose is kinked, compressed, or otherwise damaged
• Wrong Drain Hose used (use only supplied Sharp Dishwasher Drain
Hose)
E4 Overow Some element of dishwasher leaks
E8 Failure of orientation of distributary valve Open circuit or break of distributary valve
E9 Holding a button for longer than 30 seconds Water or some other material on the button
WARNING
• If overow occurs, turn off the main water supply before calling for service.
• If there is water in the base pan because of an overll or small leak, the water should be removed before restarting the dishwasher.
INCORRECT CORRECT - METHOD 1
AIR GAP WITH WASTE TEE OR DISPOSER
INCORRECT CORRECT - METHOD 2
HIGH DRAIN LOOP WITH WASTE TEE OR DISPOSER
SHARP ELECTRONICS CORPORATION • 100 Paragon Drive • Montvale, New Jersey 07645 • USA