SJGF60XT
30
Remove the C-part. FI-FK. •
(When replacement of F-LED PWB ass’y)
Remove three screws and one claw, and push the
PWB backward.
: screw
C-part. FI-FK
Open the connector cover at the left back 4.
(3 claws, one screw), and disconnect one connector.
Pull out the fl atter one between the two connectors.
□ : claw
Remove the EV cover ass'y.5.
Remove four screws.1)
Remove four claws at the top, and tilt the cover 2)
to the front.
○
: screw
EV cover ass’y
Top of the EV cover
□
: claw
EV cover ass’y
Remove the Heater. (Replacement procedure)6.
CAUTION: The heater is a charged and heating part.
Use caution about the following points:
Place the electric wiring and sleeve of the Heater •
at the specified positions. Make sure that they
will not touch the metal edges of the cooling unit,
heater cover, etc.
Be sure not to damage the piping of the cooling •
unit.
When connecting the connector, check for a •
connector insertion fault.
After replacement of the heater, check continuity •
and insulation.
When handling the heater, hold the rubber cap. Do
not touch the glass pipe with a bare hand. If you
touch the glass pipe, wipe grease off completely.
Pull the top of the evaporator to the front, and 1)
raise it slightly.
Pull out the evaporator obliquely.2)
Twist the straight pipe at the top of the accumulator •
so that the evaporator will not be deformed.
CAUTION
When pulling out the evaporator and bending •
the pipe, use caution so that the pipe will not be
broken or remarkably deformed.
Be careful not to get injury with the fins.•
Evaporator
To Next Page
Loading...
