SJGF60XT
31
Remove the aluminum tape that fastens the lead 3)
wire to the drip tray.
Screw
Heater AL
Aluminum tape
Screw
Remove two screws, and remove the heater AL.4)
Open the heater fastening part of the heater AL to 5)
the right and left, and replace the heater.
Fastening part
Heater
Insert the lead wire in the groove of the drip tray, 6)
and apply the aluminum tape to fasten the lead
wire.
Lead wire
Aluminum tape
Groove of drip tray
Re-mount the evaporator in the original condition.7)
CAUTION
Put the bottom of the evaporator on the rib of the •
drip tray, and place the projection of the food liner
at the position shown in the figure.
Set the accumulator piping angle as shown in the •
figure.
Make sure that the pipe is not remarkably •
deformed.
Accumulator
Fastening part
HOW TO REMOVE OP. PWB ASS'Y4.
Insert a thin flathead screwdriver (or a steel scale) 1.
into the slot at the back of the PWB cover to unhook
the claws.
: claw
PWB cover
Remove the connector (1 place) and pull out the 2.
PWB.
Op. PWB ass'y
Connector
HOW TO REMOVE TERMINAL BOX5.
Remove screws (2 places).•
Terminal box
○
: screw
To Next Page
Loading...
