Sharp SJ-GF60X-T

SJGF60XT
41
Fasten the packing holder to the assembly of Step 2 with two screws.3.
Tightening torque is 3.5 to 4.5 kgf/cm (0.34 to 0.44 Nm).•
Insert the gear pump harness in the groove of the R-C box, and bend the R-C box hinge so that the Claw is •
securely engaged.
Attach the gear pump harness inserted in the R-C box groove to the Claw of the R-C box securely.•
Screw
Screw
Packing holder
Hinge
En
g
a
g
e the hook.
Groove of R-C bo
x
Attach the harness to the hook.
Insert the joint pipe to the gear pump.4.
Insert securely.•
Attach the joint pipe vertically as shown the figure.•
Mount the R-thermistor to the R-C box.5.
Gear pump
R-thermistor
Attach the harness
to the hook.
Paper tape
Attach the joint pipe vertically
Joint pipe
Attach A-sealer R-FM S to the fan motor, and mount it to the R-C box insu. A.6.
0～ 2
A-sealer R-FM S
Fan motor
A-sealer R-FM S
R-C box insu.A
Butt
Label is located on this side.
(Use caution about orientation.)