SJGF60XT
49
Cover Ice cube tray AT with Ice heater cover T.3.
* Set Ice heater cover T so as to "
" marking side is on axis of Ice cube tray AT.
* Tightening toruque is 0.5N•m.
Ice cube tray AT
Ice heater cover T
Screw
Marking “ ”
Axis
Put rib of Ice senser in groove of ice maker ass'y, and fi x Ice senser to Ice maker ass'y by tapping screw.4.
* Put head of Ice senser points fi nal gear of Ice maker ass'y.
* Use jig to prevent variability fi xing Ice senser.
* Tightning torque is 0.5N m.
Screw
Ice maker ass’y
Ice maker ass’y
Final gear
Move this direction
(remove backlash)
Groove
Rib
Head
Ice senser
Insert the assembly of Step 3 to the assembly of Step 4.5.
Make sure that the ice cube tray AT is attached in the right direction. •
(The ice making section comes to the mounting foot side of the ice maker ass'y)
Insert it all the way inside the fi nal gear so that it fi ts fi rmly. •
Ice cube tray AT
Ice maker ass’y
To Next Page
Loading...
